SOURCEFORGE » RALF » 2015 Evaluation and test of an optical / L-band tranceiver

{{toc}}

h1. 4. Results

This section explains how the Outdoor system has been installed and the results obtained measuring a real TV signal from a Satellite. 

p=. !{width:300px}transrecv.jpg!

Optical system (transmitter + fiber + receiver)

h2. 4.1 Preparation

The optical transmitter has been put in an hermetic box.

p=. !{width:300px}installation.jpg!

Hermetic box installed outdoors

Its interface consists of :

* The power supply plug to be connected to the mains ;

* The optical fiber harness (2 fibers) : only the red fiber is actually connected to optical transmitter ; the black fiber is not used, it will enable to have a b ;

* The type F coaxial cable to connect the Antenna Low Noise Block, LNB, to optical transmitter.

Optical transmitter is set to :

* To supply 18 V to LNB, which selects Horizontale polarization ;

* To provide 0 kHz tone to LNB, which set its Local Oscillator to 9.75 GHz to transpose lower Ku Band from  10.7 to 11.7 GHz into IF Band.

* This hermetic box has been mounted on Antenna mast. This Antenna is pointing to Astra 1KR/1L/1M/1N colocalized satellites on 19.2° East.

h2. 4.2 Trials

h3. 4.2.1 Inter Frequency Spectrum with Optical Link

RF output from Optical receiver has been analyzed with Rohde & Schwartz FSV spectrum analyzer :

p=. !{width:600px}rsz_1combine_images.png!

_IF Band, 1 Channel (with Optical Link)_

It is possible to distinguish several channels within the Inter Frequency, IF, band. There is a zoom on left side. The 3 dB channel bandwdith is 22 MHz.

The power is about -32 dBm for the channel centered around 1141 MHz.

p=. !{width:300px}rsz_tv_channel.png!

_TV channel at 1141 MHz_

h3. 4.2.2 Link Quality with Optical link

p=. !{width:500px}Field_trials_setup.jpg!

Measurement setup based on TV, Tuner, IPRICOT SCB router with Optical Receiver (On screen : Einsfestival program on 10744 MHz Horizontal Polarization)

First, optical link performance enables to have a good TV quality (for example, Einsfestival Plus on 10744H).

Channel power and 3 dB Channel bandwidth have been checked with Spectrum Analyzer.

More deeply, physical link quality has been assessed with the information provided by IPRICOT SCB router :

* IPRICOT confirms that input signal is a QPSK modulation with Forward Error Correction Rate of 5/6 (RX_SIG & VITSYNC set to green). Moreover, IPRICOT is able to get the Frame Synchronization (FSYNC set to green) ;

* Eb/No is reported by IPRICOT.

This data has been compared with data from website like [www.lingsat.com] :

p=. !{width:400px}table_channels.jpg!

Summary Table

p=. !{width:500px}IFSignal_994MHz.PNG!

Channel Bandwidth & Power at 994 MHz (Ku channel @ 10744 MHz)

p=. !{width:500px}rsz_ipr_sc.png!

Physical link parameter at 10744 MHz

|/2 Ku Channel [MHz]|/2 IF Channel [MHz]|_. TV|\2=. www.lingsat.com |\2=. Spectrum Analyzer|\2=. IPRICOT|

|=. Channel|=. Physical Protocol|=. EIRP[dBW]|=. 3 dB CH BW [MHz]|=. CH Power [dBm]|=. Physical Protocol|=. Eb/No[dB]|

10744H|994|Eins Plus|DVB-S QPSK 22 Msps 5/6||About 22|-31.94|DVB-S QPSK 22 Msps 5/6|7.7

11244H|1494|Schau TV|DVB-S QPSK 22 Msps 5/6||About 22|-32.81|DVB-S QPSK 22 Msps 5/6|7.9