SOURCEFORGE » RALF » 2015 Evaluation and test of an optical / L-band tranceiver

{{toc}}

h1. 4. Results

This section explains how the Outdoor system has been installed and the results obtained measuring a real TV signal from a Satellite.

p=. !{width:300px}transrecv.jpg!
Optical system (transmitter + fiber + receiver)

h2. 4.1 Preparation

The optical transmitter has been put in an hermetic box.

p=. !{width:300px}installation.jpg!
Hermetic box installed outdoors

Its interface consists of :

* The power supply plug to be connected to the mains ;
* The optical fiber harness (2 fibers) : only the red fiber is actually connected to optical transmitter ; the black fiber is not used, it will enable to have a b.
* The type F coaxial cable to connect the Antenna Low Noise Block, LNB, to optical transmitter.

Optical transmitter is set to :

* To supply 18 V to LNB, which selects Horizontal polarization.
* To provide 0 kHz tone to LNB, which set its Local Oscillator to 9.75 GHz to transpose lower Ku Band from 10.7 to 11.7 GHz into IF Band.
* This hermetic box has been mounted on Antenna mast. This Antenna is pointing to Astra 1KR/1L/1M/1N co-localized satellites on 19.2° East.

p=. !{width:300px}Mast_Setup.jpg!
Hermetic box installed on Antenna Mast

h2. 4.2 Trials

h3. 4.2.1 Inter Frequency Spectrum with Optical Link

RF output from Optical receiver has been analyzed with Rohde & Schwartz FSV spectrum analyzer :

p=. !{width:600px}rsz_1combine_images.png!
_IF Band, 1 Channel (with Optical Link)_

It is possible to distinguish several channels within the Inter Frequency, IF, band. There is a zoom on left side. The 3 dB channel bandwdith is 22 MHz.
The power is about -32 dBm for the channel centered around 1141 MHz.

p=. !{width:300px}rsz_tv_channel.png!
_TV channel at 1141 MHz_

h3. 4.2.2 Link Quality with Optical link

p=. !{width:500px}Field_trials_setup.jpg!
Measurement setup based on TV, Tuner, IPRICOT SCB router with Optical Receiver (On screen : Einsfestival program on 10744 MHz Horizontal Polarization)

First, optical link performance enables to have a good TV quality (for example, Einsfestival Plus on 10744H).

Channel power and 3 dB Channel bandwidth have been checked with Spectrum Analyzer.

More deeply, physical link quality has been assessed with the information provided by IPRICOT SCB router :
* IPRICOT confirms that input signal is a QPSK modulation with Forward Error Correction Rate of 5/6 (RX_SIG & VITSYNC set to green). Moreover, IPRICOT is able to get the Frame Synchronization (FSYNC set to green) ;
* Eb/No is reported by IPRICOT.

This data has been compared with data from website like [www.lingsat.com] :

|/2. Ku Channel [MHz]|/2. IF Channel [MHz]|_. TV|\2=. www.lingsat.com |\2=. Spectrum Analyzer|\2=. IPRICOT|
|=. Channel|=. Physical Protocol|=. EIRP[dBW]|=. 3dB CH BW [MHz]|=. 3dB CH Power [dBm] |=. Physical Protocol|=. Eb/No[dB]|
|=. 10744H |=. 994|=. Eins Plus|=. DVB-S QPSK 22 Msps 5/6|=. |=. About 22|=. -31.94 |=. DVB-S QPSK 22 Msps 5/6|=. 7.7|
|=.11244H |=. 1494|=. Schau TV |=. DVB-S QPSK 22 Msps 5/6|=. |=. About 22|=. -32.81 |=. DVB-S QPSK 22 Msps 5/6|=. 7.9|

p=. !{width:500px}rsz_ipr_sc.png!
Physical link parameter at 10744 MHz

h3. 4.2.3 Link Quality with Coaxial Cable

Optical link have been replaced by coaxial cable. Similar measurements have been carried out.

p=. !{width:500px}rsz_ipr_sc.png!
Spectrum at 944 MHz (related to 10744 MHz H)

p=. !{width:500px}coax_10744H.png!
Physical link parameter at 10744 MHz

h3. 4.2. Link Quality with Coaxial Cable