Wiki » History » Version 33

GOMEZ, Ramon, 12/12/2015 05:59 PM

1 2 GOMEZ, Ramon
h1. 1. Introduction
2 33 GOMEZ, Ramon
{{toc}}
3 32 GOMEZ, Ramon
[[Sidebasdar]]
4 4 GOMEZ, Ramon
Earth stations are based on an indoor/outdoor unit architecture. The outdoor unit comprises antennas and the RF frontend (amplifier and up/down converter). The indoor unit includes the receiver, modem and network/application appliances. On typical consumer systems, the outdoor and indoor units are connected by means of a 75-ohm coaxial cable. The cable conveys the intermediate frequency (typically L band) signal between the indoor/outdoor units. 
5 6 GOMEZ, Ramon
6 28 GOMEZ, Ramon
This approach, while being cost effective, is not optimal from a signal quality standpoint and might severely impair the end-to-end link budget. For example, typical attenuation values for a coaxial cable at a frequency of 1 GHz are in the order of 15 dB/100m.
7 1 GOMEZ, Ramon
8 5 GOMEZ, Ramon
The objective of this project is to test and evaluate a system that makes possible to convert the L-band RF signal from/to optical and use an optical fibre (up to 10 km) as primary interconnection media.  The signal is converted from optical back to RF in the indoor unit. As such, it is directed to DTH (Direct-To-Home) TV systems.
9 5 GOMEZ, Ramon
10 5 GOMEZ, Ramon
11 4 GOMEZ, Ramon
h1. 2. Elements and technical features  
12 4 GOMEZ, Ramon
13 28 GOMEZ, Ramon
As discussed in the introduction, an optic system will be implemented throughout this project trying to improve and replace and the classical 75-ohm coaxial cable. In order to do so the schema below represents the elements used and the configurations adopted:  
14 1 GOMEZ, Ramon
15 27 GOMEZ, Ramon
!schema.jpg!
16 27 GOMEZ, Ramon
17 28 GOMEZ, Ramon
As it has been presented before, the project consist of an indoor and outdoor parts
18 28 GOMEZ, Ramon
* Outdoor: consists of the L-band reception antenna, the coaxial cable relying the antenna and the modulator transmitter (allows to convert from L-band to optic frequencies) and the 30m of Monomode fiber optic, FO. 
19 28 GOMEZ, Ramon
* Indoor part: consists of the receiver L-band/optic demodulator and the coaxial cable to rely the demodulator with the TV. 
20 28 GOMEZ, Ramon
21 28 GOMEZ, Ramon
22 28 GOMEZ, Ramon
///////////////////////////Write here technical details of each systems/////////////////////////
23 27 GOMEZ, Ramon
24 27 GOMEZ, Ramon
_Remark: As the aim of the project is to characterise the fiber system we have substitute the TV by an spectrum analyser in order to evaluate the performances._    
25 4 GOMEZ, Ramon
26 4 GOMEZ, Ramon
h1. 3. Measures
27 4 GOMEZ, Ramon
28 6 GOMEZ, Ramon
h2. 3.1 Linearity
29 6 GOMEZ, Ramon
30 6 GOMEZ, Ramon
h2. 3.2 Intermodulation
31 6 GOMEZ, Ramon
32 6 GOMEZ, Ramon
h2. 3.3 Phase/Noise
33 4 GOMEZ, Ramon
34 6 GOMEZ, Ramon
h1. 4. Results
35 1 GOMEZ, Ramon
36 26 GOMEZ, Ramon
h1. 5. Application
37 7 GOMEZ, Ramon
38 7 GOMEZ, Ramon
This section explains how the Outdoor system has been installed and the results obtained measuring a real TV signal from a Satellite. 
39 7 GOMEZ, Ramon
40 26 GOMEZ, Ramon
h2. 5.1 Preparation
41 7 GOMEZ, Ramon
42 7 GOMEZ, Ramon
The optical transmitter has been put in an hermetic box.
43 7 GOMEZ, Ramon
44 7 GOMEZ, Ramon
Its interface consists of :
45 7 GOMEZ, Ramon
46 7 GOMEZ, Ramon
* The power supply plug to be connected to the mains ;
47 7 GOMEZ, Ramon
* The optical fiber harness (2 fibers) : only the red fiber is actually connected to optical transmitter ; the black fiber is not used, it will enable to have a b ;
48 7 GOMEZ, Ramon
* The type F coaxial cable to connect the Antenna Low Noise Block, LNB, to optical transmitter.
49 7 GOMEZ, Ramon
50 7 GOMEZ, Ramon
Optical transmitter is set to :
51 1 GOMEZ, Ramon
52 1 GOMEZ, Ramon
* To supply 18 V to LNB, which selects Horizontale polarization ;
53 7 GOMEZ, Ramon
* To provide 0 kHz tone to LNB, which set its Local Oscillator to 9.75 GHz to transpose lower Ku Band from  10.7 to 11.7 GHz into IF Band.
54 7 GOMEZ, Ramon
* This hermetic box has been mounted on Antenna mast. This Antenna is pointing to Astra 1KR/1L/1M/1N colocalized satellites on 19.2° East.
55 7 GOMEZ, Ramon
56 26 GOMEZ, Ramon
h2. 5.2 Trials
57 7 GOMEZ, Ramon
58 26 GOMEZ, Ramon
h3. 5.2.1 Inter Frequency Spectrum with Optical Link
59 1 GOMEZ, Ramon
60 14 GOMEZ, Ramon
RF output from Optical receiver has been analyzed with Rohde & Schwartz FSV spectrum analyzer :
61 14 GOMEZ, Ramon
62 1 GOMEZ, Ramon
!rsz_1combine_images.png!
63 14 GOMEZ, Ramon
_IF Band, 1 Channel (with Optical Link)_
64 1 GOMEZ, Ramon
65 14 GOMEZ, Ramon
It is possible to distinguish several channels within the Inter Frequency, IF, band. There is a zoom on left side. The 3 dB channel bandwdith is 22 MHz.
66 13 GOMEZ, Ramon
The power is about -32 dBm for the channel centered around 1141 MHz.
67 1 GOMEZ, Ramon
68 9 GOMEZ, Ramon
!rsz_tv_channel.png!
69 14 GOMEZ, Ramon
_TV channel at 1141 MHz_
70 1 GOMEZ, Ramon
71 26 GOMEZ, Ramon
h3. 5.2.2 Link Quality with Optical link
72 1 GOMEZ, Ramon
73 14 GOMEZ, Ramon
First, optical link performance enables to have a good TV quality (for example, Eins Plus on 10744H). More deeply, physical link quality has been assessed with the information provided by IPRICOT SCB router.
74 20 GOMEZ, Ramon
This data has been compared with data from website like [www.lingsat.com] :
75 15 GOMEZ, Ramon
76 1 GOMEZ, Ramon
!table_channels.jpg!
77 1 GOMEZ, Ramon
78 21 GOMEZ, Ramon
!rsz_ipr_sc.png!
79 22 GOMEZ, Ramon
Physical link parameter at 10744 MHz
80 23 GOMEZ, Ramon
81 25 GOMEZ, Ramon
!rsz_ipr_sc2.png!
82 22 GOMEZ, Ramon
Physical link parameter at 11244 MHz
83 26 GOMEZ, Ramon
84 26 GOMEZ, Ramon
h1. 6. Conclusions