Main Page » History » Version 51

Cuadro, Juan Pablo, 12/15/2014 12:23 PM

1 34 Cuadro, Juan Pablo
h1. Satellite Channel Emulation
2 35 Cuadro, Juan Pablo
3 19 Cuadro, Juan Pablo
----
4 19 Cuadro, Juan Pablo
5 20 Cuadro, Juan Pablo
This is the Wiki page for the SCS 2014/2015 project #1. It deals with DVB-S2 and its novel ACM feature.
6 20 Cuadro, Juan Pablo
7 50 Cuadro, Juan Pablo
{{>toc}}
8 46 Cuadro, Juan Pablo
9 38 Cuadro, Juan Pablo
h2. Table Of Contents
10 38 Cuadro, Juan Pablo
11 50 Cuadro, Juan Pablo
* [[Main Page|Introduction]]
12 50 Cuadro, Juan Pablo
* [[DVB-S2]]
13 50 Cuadro, Juan Pablo
** [[Overview]]
14 50 Cuadro, Juan Pablo
** [[Adaptive Coding and Modulation]]
15 50 Cuadro, Juan Pablo
** [[FlexACM]]
16 50 Cuadro, Juan Pablo
* [[Lab Setup]]
17 50 Cuadro, Juan Pablo
** [[Link Emulator]]
18 50 Cuadro, Juan Pablo
** [[Newtec EL470]]
19 50 Cuadro, Juan Pablo
*** [[Configuration]]
20 50 Cuadro, Juan Pablo
** [[Measuring Tools and Scripts]]
21 50 Cuadro, Juan Pablo
* [[Results and Conclusions]]
22 49 GAY, Adrien
23 46 Cuadro, Juan Pablo
24 38 Cuadro, Juan Pablo
25 19 Cuadro, Juan Pablo
h2. Progress
26 19 Cuadro, Juan Pablo
27 25 Cuadro, Juan Pablo
+@Tasks:@+
28 1 Cuadro, Juan Pablo
29 1 Cuadro, Juan Pablo
* %{background: none}@DVB-S2 Section:@%
30 51 Cuadro, Juan Pablo
** %{background: red}@A little bit of history.@%
31 51 Cuadro, Juan Pablo
** %{background: red}@Features vs DVB-S.@%
32 51 Cuadro, Juan Pablo
** %{background: red}@Coding and modulation schemes.@%
33 51 Cuadro, Juan Pablo
** %{background: red}@ACM(Read EL470 Manual).@%
34 51 Cuadro, Juan Pablo
*** %{background: red}@Description.@%
35 51 Cuadro, Juan Pablo
*** %{background: red}@Newtec FlexACM@%
36 1 Cuadro, Juan Pablo
37 1 Cuadro, Juan Pablo
* %{background: none}@Test Setup Section:@%
38 51 Cuadro, Juan Pablo
** %{background: red}@Newtec EL470: Description of hardware.@%
39 51 Cuadro, Juan Pablo
*** %{background: red}@Configuration: Description of IP bridging and change config@%
40 1 Cuadro, Juan Pablo
41 1 Cuadro, Juan Pablo
+@ColorReference:@+
42 1 Cuadro, Juan Pablo
* %{background: Lightgreen}@Task 1, Status: DONE@%
43 1 Cuadro, Juan Pablo
* %{background: yellow}@Task 2, Status: TODO@%
44 1 Cuadro, Juan Pablo
** %{background: Red}@SubTask 1, Status: URGENT@%
45 1 Cuadro, Juan Pablo
46 1 Cuadro, Juan Pablo
h2. Introduction
47 1 Cuadro, Juan Pablo
48 48 GAY, Adrien
Satellite systems based on the DVB-S standard are inevitably forced to adhere to fixed MODCOD parameters, that is, a fixed coding rate and modulation scheme. This in turn leaves the designer with no choice other than to dimension the system for the worst-case propagation conditions in order to have link-closure and meet availability, coverage and performance requirements. 
49 48 GAY, Adrien
50 36 Cuadro, Juan Pablo
This approach has the disadvantage that high margins in the carrier-to-noise-and-interference ratios (CNIRs) occur in the majority of cases when propagation conditions allow for it. In the case of broadcasting services, where we have a multitude of users spread over very large areas, this waste of power cannot be easily avoided. However, in point-to-point links if a return channel is present it is possible to report channel state conditions and exploit its temporal variations by adapting the code rate and modulation scheme being used so as to best match the CNIR. This way a fixed link is avoided and considerable improvements in system capacity are obtained with better utilization of power resources.
51 29 Cuadro, Juan Pablo
52 23 Cuadro, Juan Pablo
The DVB-S2 standard introduces adaptive coding and modulation (ACM) enabling better use of transponder resources when high carrier-to-noise-plus-interference ratios occur due to favorable propagation conditions. ACM allows for different coding rates and modulation schemes to be used and dynamically changed on a frame-by-frame basis.
53 1 Cuadro, Juan Pablo
54 1 Cuadro, Juan Pablo
!{width: 70%}acmLink.png(Block diagram of an ACM DVB-S2 link.)!
55 19 Cuadro, Juan Pablo
56 50 Cuadro, Juan Pablo
h2. Bibliography
57 50 Cuadro, Juan Pablo
58 50 Cuadro, Juan Pablo
In the course of this project we have used the ETSI's specifications of DVB-S as well as hardware manuals and several papers. These documents can all be found in the Documents section of this project. A list is provided here for convenience:
59 50 Cuadro, Juan Pablo
60 50 Cuadro, Juan Pablo
_User Manuals:_
61 50 Cuadro, Juan Pablo
project-channel-emulation:document#12
62 50 Cuadro, Juan Pablo
63 50 Cuadro, Juan Pablo
_Papers:_
64 50 Cuadro, Juan Pablo
project-channel-emulation:document#13
65 50 Cuadro, Juan Pablo
project-channel-emulation:document#3
66 50 Cuadro, Juan Pablo
project-channel-emulation:document#14
67 50 Cuadro, Juan Pablo
68 50 Cuadro, Juan Pablo
_ETSI Specifications:_
69 50 Cuadro, Juan Pablo
project-channel-emulation:document#1
70 50 Cuadro, Juan Pablo
project-channel-emulation:document#2
71 50 Cuadro, Juan Pablo
project-channel-emulation:document#4