BOM » History » Version 2

AGUT SANZ, Sergio, 03/22/2015 06:52 PM

1 1 AGUT SANZ, Sergio
h1.  BOM
2 1 AGUT SANZ, Sergio
3 1 AGUT SANZ, Sergio
{TODO} 
4 1 AGUT SANZ, Sergio
5 1 AGUT SANZ, Sergio
The complete bill of materials for the construction is explained in this section:
6 1 AGUT SANZ, Sergio
7 1 AGUT SANZ, Sergio
The following materials are readily available in any home improvement supermarket with a plumbing section. The metal rods, can be made of copper  or any other  conductive material, however in this project aluminium rods have been used because of their good conductive properties. Once the antenna was built, a female connector, PL 259, was  used to connect the antenna output with the receptor. Regarding the connections, a strip board was used to ensure a better connection between both parts and  to fasten the rods correctly. The list of materials can be seen in table xx  below:
8 1 AGUT SANZ, Sergio
9 1 AGUT SANZ, Sergio
10 1 AGUT SANZ, Sergio
11 1 AGUT SANZ, Sergio
12 1 AGUT SANZ, Sergio
13 2 AGUT SANZ, Sergio
{TODO} TABLE, ITS REFERENCE
14 1 AGUT SANZ, Sergio
15 1 AGUT SANZ, Sergio
16 2 AGUT SANZ, Sergio
p=. !{width: 60%}Material.png!
17 2 AGUT SANZ, Sergio
*Figure *: All material used in our design
18 1 AGUT SANZ, Sergio
19 1 AGUT SANZ, Sergio
20 1 AGUT SANZ, Sergio
In addition, the list of tools used in the construction of the antenna are the following:
21 1 AGUT SANZ, Sergio
> * Soldering
22 1 AGUT SANZ, Sergio
> * Cable stripping tool
23 1 AGUT SANZ, Sergio
> * Hacksaw
24 1 AGUT SANZ, Sergio
> * Drill 6mm, 2mm
25 1 AGUT SANZ, Sergio
> * Rasp
26 1 AGUT SANZ, Sergio
27 1 AGUT SANZ, Sergio
28 1 AGUT SANZ, Sergio
To complete the system, the following elements were necessary to collect the data:
29 1 AGUT SANZ, Sergio
> * Analog receiver
30 1 AGUT SANZ, Sergio
> * Cable with jack connection
31 1 AGUT SANZ, Sergio
> * Software: WXtolmg and WXTrack