The Microbox and Mecanical test » History » Version 5

SELVACHANDRAN, Kogulan, 03/23/2016 04:06 PM

1 1 SELVACHANDRAN, Kogulan
h1. The Microbox and Mecanical test
2 2 COSTANTINI, Martial
3 4 SELVACHANDRAN, Kogulan
Here is the final Microbox (before the tests):
4 3 SELVACHANDRAN, Kogulan
5 4 SELVACHANDRAN, Kogulan
!Mircobox.png!
6 3 SELVACHANDRAN, Kogulan
7 2 COSTANTINI, Martial
Our tests began with something simple: is the foam of the upper part of the suitcase exerting enough pressure to hold every device in place ?
8 1 SELVACHANDRAN, Kogulan
Putting the suitcase vertically was not sufficient to get anything to move, and neither were two 15 mins walk through the campus, while carrying the suitcase by hand.
9 3 SELVACHANDRAN, Kogulan
Nothing moved with this, but we did not make specific shock resistance test (dropping the box from one meter for example).
10 2 COSTANTINI, Martial
Also, we can clearly assess the ECCS class of "portable", since we can carry the box by hand without too much effort.
11 2 COSTANTINI, Martial
Our test shown that the guinea pig can stay in the "light sweat zone" if carrying the microbox over about 800m under sunny weather.
12 1 SELVACHANDRAN, Kogulan
13 2 COSTANTINI, Martial
Something important is also to test if every connector has enough space in front of it to allow something to be plugged on it.
14 3 SELVACHANDRAN, Kogulan
Those test revealed nothing worrying, except that at first, the SD card of the Raspberry Pi was very difficult to remove an to put back in.
15 2 COSTANTINI, Martial
This is no longer the case, because (we'll see that in the next section) we needed to change the IP phone. As the new phone has a different shape, it did liberate an access to the SD card.
16 2 COSTANTINI, Martial
The only drawback is that it reduced the space to put the main power cable in.
17 5 SELVACHANDRAN, Kogulan
The Microtik router is place upside down. We decided to do that in order to have access to the USB port of the router to supply power to the Raspi.
18 5 SELVACHANDRAN, Kogulan
Else, the USB port would have been against the side of the suitcase.