Implementation » History » Version 1

PASCHOS, Alexandros, 12/15/2015 12:15 AM

1 1 PASCHOS, Alexandros
{{toc}}
2 1 PASCHOS, Alexandros
3 1 PASCHOS, Alexandros
h1. Implementation
4 1 PASCHOS, Alexandros
5 1 PASCHOS, Alexandros
h2. Equipment and Sofware
6 1 PASCHOS, Alexandros
7 1 PASCHOS, Alexandros
The following equipment was used:
8 1 PASCHOS, Alexandros
* 2 NI USRPs 2910
9 1 PASCHOS, Alexandros
* 30dB Attenuator
10 1 PASCHOS, Alexandros
* MIMO Cable 
11 1 PASCHOS, Alexandros
* Ethernet Cable
12 1 PASCHOS, Alexandros
* Cohexial RF Cable SMA-SMA
13 1 PASCHOS, Alexandros
14 1 PASCHOS, Alexandros
Software:
15 1 PASCHOS, Alexandros
* NI LabVIEW Communications System Design Suite
16 1 PASCHOS, Alexandros
There is a strong escalating demand for design tools that can enable rapid prototyping. SDR platforms offer prototype designs due to tremendous flexibility. After almost 30 years of the LabVIEW [http://www.ni.com/labview/f/] (Laboratory Virtual Instrument Engineering Workbench) version 1.0, NI enables users to program both processor and FPGA. So this enables researchers to experiment with novel algorithms and techniques in protocols, advanced signaling processing and communications design techniques. So in 2015 NI launched the NI LabVIEW Communications System Design Suite.
17 1 PASCHOS, Alexandros
18 1 PASCHOS, Alexandros
h2. Limitations
19 1 PASCHOS, Alexandros
20 1 PASCHOS, Alexandros
* Frequency use was not that of satellite communications, given that the USRP has a coverage ranging from 50-2200MHz, thus, for USRP communication, L-band was used (900MHz).
21 1 PASCHOS, Alexandros
* When using BCH and LDPC codes, the  parameters were not compliant to  DVB-S2 standard, since LabVIEW cannot compute such high values. These functions were used with low values of n (up to 100).
22 1 PASCHOS, Alexandros
* Synchronization between the transmitter and the receiver USRP was hard to handle and didn't allow for proper measurement. Decoding and BER measurements were calculated in a communication chain without the use of USRPs.