Simulations and results¶

From the method described previously, we have developed three Matlab programs enabling to compute or visualize the influence of various parameters according to what is assume known or not.

Computation of the MODCOD and (G/T) required:¶

Supposing that the specifications and frequency band are known (Rb, R, f, B and EIRP are known), we directly get all the parameters for the system design by following the method described previously.

f= 869,5 MHz B= 250 kHz PAR= 0.5 W Rb=500 bits/s R=50 km:

Comment value (G/T)

f= 5 GHz B= 500 kHz EIRP= 1 W Rb=500 bits/s R=50 km:

Figure

Comment value (G/T)

Influence of the bandwidth on the EIRP:¶

If the regulatory frequency for application is known, this tool enables to visualize the tradeoff between the EIRP and bandwidth to fulfil the specifications:

f= 869,5 MHz Rb=500 bits/s R=50 km:

Figure

Comments

f= 5 GHz Rb=500 bits/s R=50 km:

Figure

Comments

Influence of the distance on the bite rate:¶

If the required system design is too constraining for a given specification, and then not achievable, we might lower our expectations and have a tradeoff between the desired bit rate and the range

f= 869,5 MHz B= 250 kHz PAR= 0.5 W

Figure

f= 5 GHz B= 500kHz EIRP= 1 W

Figure

We can notice the bite rate is dropping quickly with the range of transmission. Then, the video transmission can be lost if the aircraft moves just a little bit too far of the limit range.