Noise Figure » History » Version 41

HAENNIG, Gerald, 12/13/2015 04:18 PM

1 1 GOMEZ, Ramon
h1. Noise Figure
2 2 HAENNIG, Gerald
3 2 HAENNIG, Gerald
The Noise Figure has been measured with the FSV spectrum Analyzer.
4 2 HAENNIG, Gerald
5 2 HAENNIG, Gerald
The optical link output power is measured with an input termination (done with 50 Ohm termination instead of 75 Ohm as not available) at a temperature of 290 K.
6 2 HAENNIG, Gerald
7 2 HAENNIG, Gerald
Noise Factor :
8 2 HAENNIG, Gerald
9 2 HAENNIG, Gerald
F = No / kToBG (No : measured output power noise; k : Boltzman constant ;  To : ambiant temperature close to 290 K ; B : measurement bandwidth ; G : RF Gain)
10 2 HAENNIG, Gerald
11 2 HAENNIG, Gerald
Noise Figure :
12 2 HAENNIG, Gerald
13 2 HAENNIG, Gerald
NF=10*log10(Ftot)
14 2 HAENNIG, Gerald
15 19 HAENNIG, Gerald
The table below contains the Noise Figure measured on the optical link.
16 19 HAENNIG, Gerald
17 41 HAENNIG, Gerald
|_. Parameter |_. Unit |\5=. _.Measurements |
18 35 HAENNIG, Gerald
|_. Frequency |_. MHz |=. 700 |=. 1000 |=. 1500 |=. 2000 |=. 2300 |
19 35 HAENNIG, Gerald
|_. Optical Link Noise Figure |_. dB |=. 30.9 |=. 30.1 |=. 31.3 |=. 32.6 |=. 33.4 |