Adaptive Coding and Modulation » History » Version 5

GAY, Adrien, 12/16/2014 11:23 AM

1 1 Cuadro, Juan Pablo
h1. Adaptive Coding and Modulation
2 1 Cuadro, Juan Pablo
3 2 GAY, Adrien
Satellite systems based on the DVB-S standard are forced to adhere to a fixed coding rate and modulation scheme (called MODCOD) among the ones defined in this standard. Therefore, the MODCOD has to be chosen regarding the worst case propagation conditions (rain, fading …) in order to insure the availability, coverage and performance requirements defined by the user. This approach is reliable but not efficient as most of the time the channel conditions could enable MODCOD of higher orders with better spectral efficiency. However, this waste of capacity cannot be easily avoided for broadcasted services as users are usually spread over very large geographical areas with heterogeneous conditions of propagation.
4 3 GAY, Adrien
5 4 Cuadro, Juan Pablo
p=. !{width: 40%}fig1.png(.)!
6 1 Cuadro, Juan Pablo
7 2 GAY, Adrien
However, the DVB-S2 standard introduced point to point services with the adoption of Adaptive Coding and Modulation (ACM) in order to increase the system capacity.
8 1 Cuadro, Juan Pablo
9 1 Cuadro, Juan Pablo
ACM is a technique which makes possible to select the optimal MODCOD in real time and for each user independently, according to the state of the propagation’s channel. This is based on the existence of a return link reporting to the emitter side the conditions of the channel, that is the Es/N0. 
10 1 Cuadro, Juan Pablo
11 4 Cuadro, Juan Pablo
p=. !{width: 50%}fig2.png(.)!
12 2 GAY, Adrien
13 4 Cuadro, Juan Pablo
p=. !{width: 60%}acmLink.png(Block diagram of an ACM DVB-S2 link)!
14 4 Cuadro, Juan Pablo
ACM Signalling in DVB-S2
15 2 GAY, Adrien
16 4 Cuadro, Juan Pablo
17 2 GAY, Adrien
Therefore, by being aware of the time dependency of the channel state, the emitter can adapt frame by frame the MODCOD to match the corresponding Es/N0. Then, a fixed link is avoided and considerable improvements in system capacity are obtained with better utilization of power resources.
18 2 GAY, Adrien
19 4 Cuadro, Juan Pablo
p=. !{width: 50%}fig4.png(.)!
20 4 Cuadro, Juan Pablo
Adaptation of the MODCOD according to the time variations of Es/N0 example.
21 2 GAY, Adrien
22 2 GAY, Adrien
However, we can notice that ACM adds a lot of complexity to the system:
23 5 GAY, Adrien
* The receiver has to be able to estimate the Es/N0
24 5 GAY, Adrien
* There has to be a return link
25 5 GAY, Adrien
* The receiver has to check every frame the Es/N0 and be able to handle the transitions.