Edit History

Sidebar »

Technical Generalities and requirements » History » Version 3

DE GENDRE, Raphaëlle, 03/22/2016 03:52 PM

1 2 DE GENDRE, Raphaëlle 
h2. Principle of a thermocouple
2 2 DE GENDRE, Raphaëlle 





    3
    2
    DE GENDRE, Raphaëlle
    





    4
    2
    DE GENDRE, Raphaëlle
    
To measure the temperature, we are going to use a thermocouple. It consists of two conductor wires which are welded at one end and free at the other. The welded part is to be placed where the temperature has to be measured. By measuring the potential difference between the two ends of the wire and knowing the type of material that was used,  we can obtain the wanted temperature.





    5
    3
    DE GENDRE, Raphaëlle
    
  !Thermocouple Principle.png!





    6
    2
    DE GENDRE, Raphaëlle
    
 The physical phenomenon that is used is the Seedbeck effect. It implies that, when there is a gradient of temperature in a conductive material, an electromotrice force is observed. Therefore, if we place this conductive material in an open circuit without internal current flow , the gradient of temperature is proportionnal to the gradient of voltage.





    7
    2
    DE GENDRE, Raphaëlle
    
     grad(V)= -S(T)* grad(T)





    8
    2
    DE GENDRE, Raphaëlle
    
S(T) is the seedbeck coefficient and it depends on the material that was used and the temperature. Of course, the reference temperature has to be known in order to get the actual temperature.





    9
    2
    DE GENDRE, Raphaëlle
    
Different types of thermocouple exist using different conductive materials. They provide different range of temperature and are more or less precise. Their resistance to radiation is as well different and so is their stability. (the full list is available at...)





    10
    2
    DE GENDRE, Raphaëlle
    
  For each type of thermocouple,  there are tables linking the difference of potential at the extremities of the wire to the temperature in degrees celsius.





    11
    2
    DE GENDRE, Raphaëlle
    





    12
    2
    DE GENDRE, Raphaëlle
    
h2. RF transmission channel





    13
    2
    DE GENDRE, Raphaëlle
    





    14
    2
    DE GENDRE, Raphaëlle
    
In order to fulfill our mission, we need to set into place a simple RF communication channel. Indeed, the temperature that will be measured and sent will be a real number which will be coded in a certain number of bits. Depending on the number of bits, the range of the possible temperature will vary. Those bits will be transmitted to the transceiver and sent to the receiver. The transceiver, in the emitter case, is in charge of transforming the bits (0 and 1) into symbols, modulating them and generating the RF signals to be transmitted in pass band.  For the receiver case, it is in charge of receiving the RF signals, demodulating them and finally translating into bits again. 





    15
    3
    DE GENDRE, Raphaëlle
    
That leads to a communication system as follow:





    16
    2
    DE GENDRE, Raphaëlle
    





    17
    2
    DE GENDRE, Raphaëlle
    
h2. RTOS