SOURCEFORGE » RALF » 2015 Quantitative analysis of RF signals

h3. 1. Finding a signal to be analysed

As previously mentioned, the USRP which is used as an RF front end includes a 20-MHz-bandwitdh low-pass filter. As a consequence, we have to analyse channels that have a bandwidth lower than 20 MHz and therefore a symbol rate lower than 20 MHz.

Several geostationary satellites such as Eutelsat 21B or Eutelsat 16B have channels with a symbol rate lower than 20MHz (see "Lyngsat Website":http://www.lyngsat.com/europe.html). Let’s take Eutelsat 21B.

To catch signals from Eutelsat 21B, the dish antenna has to aim at it. The "Dishpointer Website":http://www.dishpointer.com/ allows adjusting the elevation and the azimuth of the antenna to aim at the desired satellite, given the antenna’s location on Earth. Then, it is possible to aim at Eutelsat 21B. To check that signals are actually received, a spectrum analyser is used to display the frequency spectrum at the output of the antenna. When signals are received, the different channels transmitted by the targeted satellite can be distinguished from each other as shown on the below figure.

!Power_Spectrum_Eutelsat_21B.png!

+Figure 9: Power Spectrum Eutelsat 21B+

+_Important remark:_+ _the azimuth displayed on the antenna controller does not match the one of the dishpointer. There is a shift that changes every time the antenna is deployed. To correct that shift, a TV decoder is used as soon as a strong signal is displayed on the spectrum analyser. From the different TV channels that are decoded, it is possible to identify the satellite which is currently targeted. By comparing the values of the azimuth on the antenna controller and the dishpointer, the shift of the azimuth is known and can be compensated regarding the azimuth given by dishpointer of the satellite to be aimed at._

Once the antenna aims at Eutelsat 21B, a channel of the satellite can be chosen for further analysis. "Here":http://www.lyngsat.com/Eutelsat-21B.html are listed all the channels of Eutelsat 21B. Let’s have a closer look at the channel which centre frequency is at 11,61 GHz. As the LNB embedded on the antenna is set to work at the low-frequency band to catch most of the transmitted channels of Eutelsat 21B, the centre frequency of the chosen channel will be displayed at 11,61-10 = 1,61 GHz as shown on the following figure.

!Channel_to_be_analysed.png!

+Figure 10: Chosen Channel+