PART41 » History » Version 31

« Previous - Version 31/35 (diff) - Next » - Current version
COLIN, Tony, 03/20/2016 04:21 PM


PART 4 : Position Estimation.

Once the navigation bits from at least 4 satellites have been retrieved from the acquisition/tracking part, it is possible to estimate the desired position of the receiver.


1 - Ephemeris.

GPS uses a particular algorithm in order to characterise satellite position. In comparison with GLONASS, this method requires more parameters, but less complexity.

a - Introduction of satellite orbit.


Figure 4.1 : Orbital plane positioning.

Orbital plane positioning parameters :
p=.


Figure 4.2 : Orbit positioning in the orbital plane.

Orbit positioning in the orbital plane :
p=.


Figure 4.3 : Orbital plane positioning.

Shape of the orbit :
p=.

Positioning of the satellite on the orbit :
p=.

Induced parameters :
p=.

b - GPS satellite ephemeris data.


Figure 4.4 : List of ephemeris parameters included in GPS frames.

c - GPS satellite position calculation algorithm.


Figure 4.5 : Description of the algorithm step by step.

These tables are extracted from GPS Interface Control Document [3]


2 - Navigation computation.

a - Reminder about the range impairments.

The following figure gives the impairments affecting the range in case of the GPS system as well as the correction process :


Figure 4.6 : Pseudo-range measurement extracted from [4]

b - Demonstration of the Pseudo-ranges with Least Square method.

Starting from the fact that can determine most of the elements within the pseudo-range measurement PR_sat(i) from the information provided by each satellite, we have the equation :


Equation 1

or put in another way,


Equation 2

Indeed 4 measurements are needed, providing 4 equations with 4 unknows which are the receiver coordinates and the clock bias of the receiver. As the equation is highly non-linear, it is important to proceed to a linearization such as the Taylor expansion :


Equation 3

Hence,


Equation 4

In practise, for a receiver located e.g. in France PR (t_0) can be described by Paris location as initialization for the algorithm.
In vectorial form the equation becomes :


Equation 5

which can be expressed as :


Equation 6

with the Least Square solution :


Equation 7

Thus, it is possible to retrieve the receiver position.

Note that all unknowns are depicted in red color.

c - Kalman filter.

Another position estimation method is Kalman filter i.e. an algorithm that uses a series of measurements observed over time, containing statistical noise and other inaccuracies, and produces estimates of unknown variables that tend to be more precise than those based on a single measurement alone.
In this project, a single measurement will be used for "simplicity" purposes, therefore, the Least Square method is more appropriate for this issue.


References :
[1] K. Borre, D. M. Akos, N. Bertelsen, P. Rinder, S. H. Jensen, A software-defined GPS and GALILEO receiver
[2] M. Bousquet, Orbits and Satellite Platforms lecture script, January 2016
[3] GPS Interface Control Document under http://www.gps.gov/technical/icwg/IS-GPS-200H.pdf
[4] Position Estimation Workshop, March 2016