SOURCEFORGE » RALF » 2016 NOAA: receiving weather images

h1. Receiving antenna building

h2. List of components

h2. Assembly

h2. Testing

In order to ensure the fact that the antenna is functioning well, we made several tests.

At first, we had to ensure that the cables will really bring the phase shift of a Pi/2 between opposite dipoles. To do so, we plugged in the cables to a signal generator. We generated a sine signal at 137MHz and observed on an oscilloscope the signal at the output of two cables which have a different length as explained in the design part. Here you can find pictures of the signal generator and the observed signal at the ouput.

p=. 

!{width:60%}PhaseShift2.jpg!

!{width:60%}PhaseShift.jpg!

We see that the phase shift between the two cables is about Pi/2.

Then, at each step during the assembly, we tested each connection with a multimeter in order to ensure that all connections are correctly done.

h2. Validation

Even if we tested the cables and all the connections, we need to make sure the antenna is really able to receive APT signals. So, we plugged in the coaxial cable of our antenna to a radio receiver. As an APT signal is audible once demodulated in frequency, we can determine easily if the antenna is correctly working or not. To know when a satellite pass above Toulouse, we used a tracker software called WXTrack. Here is the interface of the software:

p=. 

!{width:90%}WXtrack.jpg!

Thanks to this software, we are able to know when each NOAA satellite will be visible. To validate our antenna, we only had to turn on the radioreceiver to the correct frequency depending on the satellite which is available and listen to the signal directly at the output of the receiver. During our tests, we could correctly hear the specific signal. To have an idea, here is an example of audible APT signal:

!florida.wav!